News Center
EATON SF6 N2 Mixtures Decomposition

EATON SF6 N2 Mixtures Decomposition

The insulation characteristics and decomposition components of C4F7N/N2 gas mixture, a potential substitute for SF6, were first explored by breakdown experiments/gas chromatography–mass spectrometer. The structural properties of C4F7N molecule and the decomposition mechanism of C4F7N/N2 gas mixture were analyzed based on the density functional theory calculation and ReaxFF molecular dynamics ...

[email protected]
News Detail
  • Thermal Decomposition Properties of Epoxy Resin in SF₆/N₂ Mixture

    The results showed that thermal properties of 20% SF₆/N₂ (volume fraction of SF₆ is 20%) mixture has faster degradation than 40% SF₆/N₂ mixture. As ratio of SF₆ content decreases, thermal stability of the system decreases, and the decomposition process of SF₆ is exacerbated.

    Get Price
  • RATE CONSTANTS FOR UNIMOLECULAR DECOMPOSITION OF SF6-

    model, the decomposition rates of SF6-* for products given in (1) may be expressed by Pi k.(U,Jo)= (SF6-)" I h(2/0+1)Pvib (E Vlb.) Uj=U-Qj x J p~;:duct(E)L J LL (2/+ 1)dE, (3) £=0 50 SF6- + N2 -. SF6 + e' + N2 ; Q, = -1.06 eV-. SFs' + F + N2; Q2 =-1.18 eV (1)-. SFs + P- + N2 ; QJ =-1.58 eV,

    Get Price
  • Chemical Decomposition of High Pressure SF6/N2 (5:95

    Under the effect of the corona discharges which can occur in these equipments, part of the SF 6 and of N 2 will dissociate and lead, in the presence of even low concentrations of H 2 0 and/or 0 2, to the formation of a lot of other gaseous compounds: (SF 4 +SOF 2), SOF 4, S0 2 F 2, S 2 F 10, NF 3....Previous studies on the decomposition of SF 6 /N 2 (10:90) mixtures under coronas 3 showed that, with no impurity added, the total quantity of by-products formed is not very different from that

    Get Price
  • Thermal decomposition properties of fluoronitriles-N2 gas

    Jan 01, 2020 · We explored the thermal decomposition properties of Fluoronitriles-N 2 (C 4 F 7 N-N 2) gas mixture using as SF 6 substitute gas in GIE. The yield of main decomposition products of 10 %C 4 F 7 N-90 %N 2 gas mixture under different overheating temperature and gas pressure conditions were detected and analyzed.

    Get Price
  • SF 6 2 SF

    decomposition of these gas mixtures under such stress must be studied. In this paper, the chemical stability under negative corona of SF 6 and SF 6–N 2 (10:90) or (5:95) mixtures was investigated at 400kPa on adding percentages of CO 2 up to 80%. The corona discharges were generated at 23˚C in a 340cm3 experimental

    Get Price
  • Analysis of SF6/N2 gas mixture decomposition by-products in

    Conference date: 23-26 Sept. 1996. Format: PDF. Two methods have been carried out for the analysis of SF6/N2 gas mixture decomposition by-products in electric discharges: infrared spectroscopy and gas chromatography. The infrared spectroscopy is a rapid method from which we can have qualitative analysis about all the products in a mixture, except those having the same absorption lines.

    Get Price
  • Decomposition Properties of C4F7N/N2 Gas Mixture: An

    The insulation characteristics and decomposition components of C4F7N/N2 gas mixture, a potential substitute for SF6, were first explored by breakdown experiments/gas chromatography–mass spectrometer. The structural properties of C4F7N molecule and the decomposition mechanism of C4F7N/N2 gas mixture were analyzed based on the density functional theory calculation and ReaxFF molecular dynamics

    Get Price
  • Decomposition Properties of C4F7N/N2 Gas Mixture: An

    The insulation characteristics and decomposition components of C4F7N/N2 gas mixture, a potential substitute for SF6, were firstly explored by breakdown experiments/gas chromatography-mass

    Get Price
  • Separation of SF6 from Gas Mixtures Using Gas Hydrate

    Jul 27, 2010 · The three-phase equilibria of hydrate (H), liquid water (LW), and vapor (V) for the binary SF6 + water mixture and for the ternary N2 + SF6 + water mixtures with various SF6 vapor compositions (10, 30, 50, and 70%) were experimentally measured to determine the stability regions and formation conditions of pure and mixed hydrates.

    Get Price
  • Experimental study on the effect of O 2 on the discharge

    Oct 18, 2019 · Addition of O2 to C5-PFK/N2 mixtures can prevent solid decomposition products from occurring during electrical breakdown of the gas-insulated medium. Sulfur hexafluoride (SF6), the most widely used insulating medium in power equipment, is a high-greenhouse effect gas.

    Get Price
  • Thermal Decomposition Properties of Epoxy Resin in SF6/N2 Mixture

    The decomposition extent of epoxy resin in three mixed gases follows: 20% SF 6 /N 2 30% SF 6 /N 2 40% SF 6 /N 2, that is to say, in the mixture of 20% SF 6 /N 2, weight loss of epoxy resin was more severe than in the mixture of 40% SF 6 /N 2. Figure 1.

    Get Price
  • Sparking-induced decomposition of 10% SF6-90% N2 mixtures

    It concerns the decomposition of SF6/N2 mixtures (100 kPa) containing 100%, 10% or 5% of SF6, under high-energy sparks (3.6 J spark−1) generated in a 340 cm3 experimental cell between a

    Get Price
  • Thermal Decomposition Properties of Epoxy Resin in SF6/N2 Mixture

    Thermal Decomposition Properties of Epoxy Resin in SF6/N2 Mixture Wen, Hao;

    Get Price
  • COLLISIONAL DECOMPOSITION OF SF6- - NIST

    lower dielectric properties of a SF6/ N2 mixture compared to those of pure SF 6. CID processes provide the dominant destruction mechanism for SF 6- with absolute cross sections approaching 35A2 at higher energies. The decomposition cross sections of SF6- in collisions with N2 are similar to those observed for rare gas targets.

    Get Price
  • THE INERTING OF METHANE AIR MIXTURES by HALON 1301

    SF6, and nitrogen (N2) in inerting premixed ''lean1' (6%), rlstoichiometriclt (10%) , and I1rich8' (14%) mixtures of methane (CH4) and air. N2 is included as a prime example of a simple thermal and physical inertant. Methane is used as the fuel since it has been extensively studied. Previous work [SI has shown

    Get Price
  • Thermal Decomposition Properties of Epoxy Resin in SF6/N2 Mixture

    surface in SF6/N2 mixture. Also thermal decomposition process of epoxy resin was simulated by the ReaxFF force field to reveal basic chemical reactions in terms of bond-breaking order, which further verified that CO2 and H2O produced during thermal decomposition of epoxy resin can intensify degradation of SF6 dielectric property.

    Get Price
  • Formaldehyde preparation methods for pressure and temperature

    Here, an admixture of CO2 is served for real time temperature measurement based on Raman scattering. The applicability of the fast laser heating system has been demonstrated with gas mixtures of SF6 + air, SF6 + N2, as well as SF6 + N2 + CO2 at 1 bar total pressure. PMID: 26724008

    Get Price
  • Sulphur Hexafluoride - Its properties and Use as a Gaseous

    100 lb of SF6 per minute from a gas mixture con- taining up to 2% N2. When the accele f ator pres- sure drops below atmospheric, a 500 ft /min vacuum pump is used in series with the compressor to re- move the remaining gas from the accelerator. Wix- tures of SF6 and non-condensable gas will be ven-

    Get Price
  • Development Sf6 Alternative Gases in Switchgears - Switchgear

    Nov 23, 2019 · The possible candidates are introduced, which are air, N2, CO2, perfluorocarbon (PFC), hydrofluorocarbon (HFC), gas mixtures containing SF6 as shown in Figure 1 by boiling temperature. These gases do not have higher dielectric strength but lower GWP than SF6, and their boiling points are below 0 ˚C.

    Get Price
  • Application of SF6 mixture gases in GIS in Northern China

    mixtures reclaiming is quite different from reclaiming pure SF 6, plenty of work has to be done concerning SF 6 mixture preparing and recycling. SF 6-CF 4 mixture can be efficiently separated by using cryogenic separation. Meanwhile, diluted SF 6-N 2 mixtures can be effectively separated by a combined membrane/sorption technique. Moreover,

    Get Price
  • Separation of SF6 from SF6/N2 mixture using metal–organic

    Feb 15, 2015 · For the recovery or the decomposition of SF 6, several technologies have been used such as cryogenic distillation, membrane separation , , plasma decomposition , , , catalyst decomposition , high temperature decomposition , and adsorption separation .

    Get Price
  • Süleyman Sungur TEZCAN | Gazi University - Academia.edu

    In context of insulation and environmental properties, decomposition products in SF6-N2 mixtures in the presence of H2O are analyzed by Density Function Theory (DFT). Homo and Lumo structures of ten decomposition products are given with the optimized geometries employing B3LYP hybrid method at the 6-311+G(d,p) level.

    Get Price
  • Catalytic Decomposition of N2O: Best Achievable Methods and

    Dec 13, 2013 · N2O decomposition on Fe/ZSM-5 in the absence and in the presence of NO The experimental performance after N2O decomposition reaches a steady-state. The desorption of O2 always delays more than that of N2, but at lower temperature during N2O decomposition; the desorption of N2 and O2 are almost synchronic in the presence of NO.

    Get Price
  • CN102327727A - Method for recovering sulfur hexafluoride in

    The invention discloses a method for recovering sulfur hexafluoride in gas mixture by using a membrane separation method. The method is characterized by firstly removing harmful decomposition products from the gas mixture of gas mixture sulfur, carbon tetrafluoride and nitrogen gas by a filter, secondly separating the nitrogen gas from sulfur hexafluoride and carbon tetrafluoride by a membrane

    Get Price
  • Study on the Thermal Decomposition Characteristics of C5F10O

    Studies have shown that the thermal decomposition products of C 5 F 10 O/N 2 /N2 gas mixture at high temperature are C 2 F 4, CO 2, C 4 F 10, C 3 F 6, C 3 F 7 H, C 3 F 8, CF 4, C 2 F 6, C 4 F 6 O 3 and C 6 F 14. C 5 F 10 O gas decomposes at 300°C to produce a small amount of C 3 F 6, and the temperature above 400°C will produce C 4 F 6 O 3

    Get Price
  • SF6 gas Mixtures process factorys

    SF6 gas Mixtures process factorys. For continuous analysis of many binary gas mixtures comprised of H 2, CO 2, O 2, CH 4, SO 2, Ar, He, NH 3, sf6 gas, air, and others.Applications include heat treating atmospheres, welding gas mixtures, blanketing gas mixtures, Ammonia synthesis, leak detection, purge monitoring, flue gas, magnesium blanketing by sf6 gas and others.

    Get Price
  • Possible High Pressure Nitrogen-Based Insulation for

    usual SF6. Many gases and mixtures have been studied, especially from 1975 to 1985; some perfluorocarbon and chlorofluorocarbon gases and mixtures are at least as good as SF6 [l] but have undesirable chemical, toxicity, or decomposition properties; therefore N2 alone or with minimum SF6 is considered. Theory of Breakdown

    Get Price
  • The basics of high voltage switching equipment in power

    Feb 20, 2021 · High Voltage Circuit Breakers. A circuit breaker is defined as “a mechanical switching device capable of making, carrying, and breaking currents under normal circuit conditions and also making, carrying, and breaking for a specified time, and breaking currents under specified abnormal conditions such as a short circuit” (IEEE Standard C.37.100).

    Get Price
  • China OEM/ODM Supplier Sf6 Prurity Tester - LK403B SF6

    The LK403B SF6 Decomposition Ion Mobility Analyzer has been designed for controlling the SF6-quality in disconnecting switches, bus bars and circuit breakers in Gas Insulated Substations (GIS). This device allows the measurement of the contamination (total of decomposition products), the SF6-percentage based on SF6-air (or nitrogen) mixtures

    Get Price
edge-iconMaybe You Will Be Interested
toTop
Click avatar to contact us
Chat Online